Transmission of the settlement aggregated time series for balancing group settlement from BIKO to BKV — BKV view
For its BK, the BIKO delivers to the BKV the balancing-group-specific BAS time series separated into surplus and deficit, the FPE and FPI, for directly assigned sub-balancing groups additionally the BAS of the sub-balancing group, and additionally further settlement aggregated time series assigned to the BK of the BKV where applicable (NB-DZR, ÜNB-DZR, SRI, SRE). On the basis of the settlement-relevant version, the BIKO creates and sends the respectively required settlement aggregated time series for the BKA to the BKV. Only the settlement aggregated time series that has changed compared with the aggregated time series already transmitted is transmitted here. Sub-balancing groups are handled in the same way as BK. If the BKV of the sub-balancing group is identical to the BKV of the superordinate BK, additional sending of the BAS time series is not required.
Process flow from the perspective of the BKV
Process steps
Transmission of settlement aggregated time series
BKV BIKOCheck identifiers
- 13003 — Aggregated time series · AS4
Flow
Message from BIKO · AS4
Write endpoint
- Transaction created —
ERSTELLEN_PROZESSDATEN
Creates a new transaction in the backend with the data of the incoming message.
- Transaction created —
Process information
Wording of the consolidated version, profile ch. 13.8.1, p. 194.
Preconditions
- The BIKO has determined the settlement aggregated time series.
- The MaBiS-ZP for the settlement aggregated time series was activated by the BIKO at the BKV.
Results
The BKV can check the settlement aggregated time series.
First message
BIKO sends “Transmission of settlement aggregated time series” (step 1). From here on, it is the turn of the party involved on this page.
Objective
The settlement aggregated time series has been transmitted by the BIKO to the BKV.
Other views of the process
The same process through the eyes of the other parties involved: the same steps, each read from their point of view.
- View BIKO — BIKO
Notes on this page
The steps are the possible messages of this process, not a sequence — the source lists neither conditions nor alternatives. The small box on the step names the own view on the left: with ← it receives, with → it sends. Collapsed steps run between other market partners.
The connector table lists no write call for these steps. Derived from the process flow: the process begins for the own role with their message, so the transaction is created.
Applies to: 1
For this market role there is no write catalog; the step therefore shows only the command of the write call, without address and without button.
Applies to: 1